1. When Pin Type Wood Moisture Meter is used for the first time, the gear measurement can be changed according to the empirical range value of wood moisture, which gear has the smallest error, and the subsequent measurement will be in this gear.
2. If the moisture content of the wood to be measured is unknown, the gear can be determined as follows:
First, take the wood samples with the average moisture content, and use the instruments 1-7 to measure the moisture respectively.
And record the measured value of each file. Immediately after the sample is sent to the oven, it is determined by the oven drying method
moisture content. Then compare with the average value of the 7 groups, which gear is the closest to the measured value, and then measure it later
fixed in this position. If the above measurement is performed unconditionally, it is usually recommended to perform the measurement on the 5th gear. However, attention should be paid to the measurement error caused by this.
